Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
On the Cisco ASR's, there is an option to disable the security association Lifetime Kilobytes all together and just use the secs.http://www.cisco.com/en/US/docs/ios-xml/ios/security/a1/sec-cr-c3.html#wp2944599527My question is whether this needs to b...
Hello, I have a few SG500 Switches in the network for L2 access along with a bunch of bigger Cisco switches. On the Cisco switches, when we get off the config mode, a logging messages shows up, something like the below.%SYS-5-CONFIG_I: Configured fro...
Hello, I been trying to use LACP for link aggregation. However, i want the Link aggregation to be very fast and hence enabled the Fast mode on channel members, but the convergence time is still over 30 sec when i try to test this by shutting down all...
Hello, I have a small query regarding QOS Priority queuing and Shaping using MQC.Lets say i have 10 Mbps total bandwidth. and have 2 different types of Bandwidth which can be matched using ACL's.The first class i have is highest priority for me and i...
Hi,I am tying to understand this wierd behaviour when a WAN link goes down.The below logs are from a cisco 7304 router.Jul 19 08:31:57.704: %DUAL-5-NBRCHANGE: IP-EIGRP(0) 100: Neighbor 164.55.222.105 (POS3/0) is down: holding time expiredJul 19 08:3...
Hi Steve,Sorry for the delayed response. I was away for a bit.Regarding the testing, we are currently using ON mode of etherchannels which is quick and does the Job well. The problem with ON is that there is no control messages/negotiation hence when...
I am running RSTP.One more question:Is LACP slower than No Negotiation?When i have channel members configured in LACP Active/passive modes, it takes about 10 sec for the channels to go online.But when i have them configured for No negotiation (On mod...
Thanks for your Responses.I did realize that Spanning tree is delaying stuff. Running RSTP brought down the delay to 10 sec now. Trying to run some debugs to figure out why it is still 10sec.Can the convergence time get any better?Victor
Hello, Thanks for the quick responses.@GregoryYeah, the Port channel interface is configured. No issues with that part.sh etherchannel 1 summary Flags: D - down P - bundled in port-channel I - stand-alone s - suspended H - Hot-s...
