Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Ive been looking for Cisco software to manage an entire network. Lets say i have a network with 200 switches and i want to do a mass firmware upgrade on all switches is there a Cisco product which can do this? Ive been looking at Cisco Prime but ...
Hi,I was about to purchase a 3560 for my home lab to do private VLANS because I read that 3550s do not supprt pvlan. Till my suprise i can see the commands to do a private-vlan configuration on my 3550:(config-vlan)#private-vlan ? association ...
Hi,Im setting up this lab and ran into an issue. My setup is as folows:Internet ----> Asa ----> 3550 ---> vlansThe ASA is directly connected to the internet. The fa0/1 on the ASA is connected to the 3550 fa0/1. I configured that fa0/1 on the 3550 as ...
Hi,We have 2 sites connected through an ipsec site to site vpn tunnel.Ike phases are succesfull, so the vpn tunnel establishes.The problem that at one site i see tx and rx and on the other site i only have tx.So traffic is going over the tunnel only ...
Hi,We have a customer who has 2 sites, at both sites the have 2 internet connections for redundancy. In the new situation we will install 2 800 series routers. On both sites we will run HSRP for rundundancy.Now the qeustoin is, i want to run 2 differ...
Hi Jon,I got it working now, since its just my home lab i did a factory default on the ASA, works like a charm now:Type escape sequence to abort.Sending 1000, 100-byte ICMP Echos to 8.8.8.8, timeout is 2 seconds:!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!...
Its an ASA 5505, basis setup.Vlan 2 outside port 0Rest of the ports are in vlan 1, also the port thats is connected to the switch.Sent from Cisco Technical Support iPhone App
Yep correct, the subnet mask in use is 255.255.255.128, on the switch and the ASA, lets forget vlan 20 for now.Basicly what isnt working is:Thw switch wont go out to the internet even though it can ping his gateway.With this i mean it has a routed po...
Jon,sorry made some typo's, to clear things up:Subnets are correct and the static route on the asa to the 10.129.242.0 network via 10.128.242.15. If I ping my client in vlan 20 from the asa, 10.129.242.10 its succesfull. I can also ping the inside in...
