Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello good day, I am facing some issues with the Cisco UCS indicated in the subject, I have created a Raid 1 beetwen 2 HDD's of 1 TB each one, also upgraded the firmware of the UCS with the 2.0(3f) HUU tools, and upgraded everything. Then I installed...
Hi everyone!! I want know if is possible disable the document camera in cisco ex series. I want the picture will not be reversed to lower the camera. Regards!
Hello, I just found an issue with TMS 14.1.1, the case is whenever endpoint x, and endpoint y for example and in a point to point call, and there's a booked conference which is going to start, that has participant x, while x and y are currently in po...
Hi, Before, when a point to point call is initiated, in tms the call appeared as active but not now. someone knows why this can happen ?? I review the option : "Administrative tools / Configuration / Netword Setting / Enable Ad Hoc Conference Discov...
Hello, I'd like to know if there is a document somewhere stating which systems could be registered with TMS 13.2.1 and TMS 14, because we were thinking of upgrading the TMS or not, also we had a bunch of systems, old ones too which we're not that sur...
Ok, I feel kind of dumb now, I have checked the tech evaluation page on Microsoft, and if it's not connected to the internet it will not inherit the three months evaluation trial, which I thought would come activated already, and only allows you up t...
Hi,Thanks for you response. The codec is high and the client needs rotate the camera to down...He needs that the camera don´t becomes "reversed" Regards!
Hmmmm tested the behavior, and whenever the endpoint receives the call scheduled from TMS drops the call, and gets called to join the conference, just to confirm this behaviour.
Hello Patrick, thanks for your answer, I'm going to try this, I will disable SNMP on one endpoint to test the P2P call VS the scheduled conference with MCU, and see if that endpoint still manages to get disconnected by the TMS to join the conference.
Thanks for you reply.I enable anonymous authentication to tms/public/ and now, work properly. There are some guideline whith the datails about how configure the IIS in server?? Regards!!!!
