Hi there,my question is the following:given that you use the vic 1240 mLOM + 1280 mezz for "real" redundancy in a M3 blade + 2208 IOM, that creates 4 different port channels composed of 2 x 10GbE KR lanes each.Then when creating a vNIC in your servic...

Hi there,my question is the following:given that you use the vic 1240 mLOM + 1280 mezz for "real" redundancy in a M3 blade + 2208 IOM, that creates 4 different port channels composed of 2 x 10GbE KR lanes each.Then when creating a vNIC in your servic...

Hello,How can I install the las VEM version part of the nx1kv 1.4a on vSphere 5? All the vibs are for 4.x plateform.I tried all of them, with no success.Thank you for your help

Hi there,I'm testing the VSG with vPath, managed by the VNMC.Everything work fine, until i have used a rdp(27) protocol rule.Indeed, if I create a permit rule with the rdp(27) protocol ahead a deny all rule, the term monitor shows the tcp 3389 goes t...

Hi there,my problem is that when i migrate vms from the standard vswitch to the nexus 1000V, some of them are loosing connection but the ports are up in the nexus.other vms (in the same vlan) keep their connection after being migrated in the same por...