cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
510
Views
0
Helpful
0
Replies

vNIC pinning to HW port channel in UCS

nvermande
Level 1
Level 1

Hi there,

my question is the following:

given that you use the vic 1240 mLOM + 1280 mezz for "real" redundancy in a M3 blade + 2208 IOM, that creates 4 different port channels composed of 2 x 10GbE KR lanes each.

Then when creating a vNIC in your service profile and linking it to one specific fabric, this gives 2 port channel available per fabric. How is the vNIC pinned to the port-channel, round-robin or? Is there any way to identify those PC + pinning with the FI CLI or GUI?

Cheers,

Nicolas

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card