Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Do you now if CoA ACK message must use the same source IP address than the CoA request destination IP address ?
In my case ISE send a CoA request to the IP address 192.168.1.100 and the switch answers (CoA ACK) with another source IP address. ...
Hi all,
Do you know if it is possible to use PIM SM and PIM SSM on the same router ? I would like to use ACL to do that but I don't know if SM and SSM are compatible with each other.
Thanks
Thibault
Hello, I have to configure AAA on HP 6125 (c7000 enclosure) with ISE for SSH and TELNET access.It works for TELNET but not for SSH. Attributes sent in access-accept for TELNET are the following:Huawei-Exec-Privilege = 3login-Service = 00 is for TELNE...
Hello,I diffuse in my network multicast video from wired to wireless with videostream feature enable. I am surprised to see that multicast are converted to unicast frame and marked with COS 4 only if I configured a media stream (wireless => media str...
Hello,I would like to use mDNS AP to send mDNS packet to the WLC (source vlan are not visible to the WLC).I saw in the documentation that APs can either be in access or trunk mode to learn the mDNS packets from wired side and forward it to the contro...
It doesn’t work for me neither with wlc 8.5.
The client is associated to the SSID, the VLAN, got an IP address but the traffic doesn’t pass.
Is someone found the solution ?
Thank you
I've just received the BUG ID for the schema : CSCvd85620. It may not be visible at this time but it should be soon.Apparently, they've released the one click feature without try it :-).
Using a custom schema doesn't work......I've opened a case at Cisco few weeks ago, it should be an enhancement in the future.I can't use use the one click feature because of that :ENH: One-Click approval does not work with the "Only accounts assigned...
