Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a distribution network that uses multiple L3 switches that route end points using OSPF routing protocol. The various L3 switches are connected using /30 point to point subnets. I can only get HSRP (or VRRP ) to work with adjacent L3 switches a...
I have a WLC that has two identical ACS 5.5 used as RADIUS for authentication. The primary works fine without any issues. The secondary (relative to the WLC) is having authentication issues. There is no path issue between the WLC and the two ACSs. I ...
I have a WS0C3850-24P switch running cat3K_caa_universalK9 software image. Does anyone know why HSRP commands (ie. 'Standby 1 ...' ) are not on this image?
If I look at all the commands on the privileged exec (config-if) level I do not see the 'stan...
I have small business customers that were perfectly sized to afford the UC320 to UC540 type of deployments. UC320's have been end-of-sale for a while now and UC540's go end-of-sale this month. What's a replacement for these that is in the same price ...
I'm following the Installation guide for Call Manager Express and am now trying to load the phone firmware for a phone running SCCP (page 65 of the guide). The summary steps are: 1. enable2. configure terminal3. tftp-server device:firmware-file4. tel...
Yes, to answer your question about vans and trunks. That was one of the first thing I checked. Also verified that same native vlan is used in each L2 switch and that its local interface is ‘up’
That’s what I thought! When I run ‘debug standby packets’ from CLI , I see that the HSRP ‘out’ messages are being dispatched on both L3 switches but no ‘in’ packets are received.
Do do I need some special CEF setting on the L2 switches?
That’s what I thought! When I run ‘debug standby packets’ from CLI , I see that the HSRP ‘out’ messages are being dispatched on both L3 switches but no ‘in’ packets are received.
Do do I need some special cef setting on the L2 switches?
