Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, i am trying to understand the output of the "show inventory" command. i am trying to build device -> card -> port/transceiver relations based from a machine perspective.. i.e., not a human that can go and read the descriptions i am also tryin...
Hello,
i am trying to solve a scam attack for my company. to whomever is reading this. this is a long one, please be patient the actual question is at the very bottom.
we are receiving email from our own domain...... iv'e been able to use Exchange ...
Hello,question.....i have a Cisco IOS router behind a NAT modem/router (Netgear), and an ASA 5505 directly facing the internet.i am trying to build an IPSEC tunnel between them.... is that possible?how would i even approach this design?trying to reso...
Hello Robert,
thanks for replying.
i have not seen these. i have tried it now but... it did not work as well.
the reason being (in my mind) that the ironport relies on the header to be RFC compliant, so if going back to my example and i remove the co...
