Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am investigating poor performance of a Cisco wireless network and think the issue may be caused by channel interferance from other accesspoints not controlled by my WLC. I have a 2504 and two 2600 series APs in an open plan office, I also hav...
Hi,I have a WLC2504 with three SSIDs configured and I have noticed that when my laptop connects to the main one it will only connect at 5.5Mbs. When I connect to the other two I get the full 72Mbps that my wireless card will allow. I have checked the...
Hi,I need to replace an older 3560 with a new 2960-S and am wondering if the SX SFPs I already have will be compatible with the 2960-S. Switch#sh inventoryNAME: "1", DESCR: "WS-C3560-48PS"PID: WS-C3560-48PS-S , VID: V04, SN: CATXXXXXXXXXNAME: "Giga...
Hi there,I tried to upgrade the IOS on my internal AP and now I am in a reboot cycle. I have tried to manually boot the old and new IOS images from the rommon but neither are working. here is the output I am getting:ap: dir flash:Directory of flash:/...
Hi Guys, Thanks for your suggestions on this but the issue is now resolved. Unfortunately I am not certain what resolved it as it went away after about 2 weeks. Thanks!
Hi,I had actually modified the DCA settings today to try and force it to do something. I had checeked all four boxes and set the sensitivity to high. This made no difference to the channel setting with both APs still on channel 1. I then manually mov...
Hi,I checked the SSIDs and all of them have all selected for the radio policy. Is there a command I can use to see how each SSID is configured so I can compare them and see whats different?Gerry
Hi Grant thanks for your input... here is the output of that command:Switch#sh idprom interface gigabitEthernet 0/2General SFP Information-----------------------------------------------Identifier : 0x03Connector : 0x07Trans...
Hi,The SFPs are Cisco original products. We had another identical switch fail and they had Cisco originals installed with a very similar serial number.
