Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 5505 at home with a 10M/1M ADSL connection. The issue I am experiencing is that when the upload gets saturated my download speed drops and latency goes through the roof (over 1000 ms). I think prioritizing outgoing TCP ACKs should solve the ...
We are currently in the process of deploying a new Cisco phone system. We are trying to figure out where to terminate the MPLS connection. The SIP trunk is being delivered over the MPLS connection. Currently, the MPLS link terminates directly into ou...
I have a 3560X that I needed to add fiber ports on. I read that the switch supports hot swap network modules. I successfully installed the C3KX-NM-1G network module. I configured the 1st fiber port (GigabitEthernet 1/1) but I am not able to pass any ...
I have two data centers each with a Nexus 7000. The two Nexus cores are directly connected with 10G Layer 2 trunks. In addition, each Nexus has an MPLS connection that connects to the edge sites. Below are the configs:Primary DataCenter / Primary MPL...
Hi, I have two Nexus 7K, one at each datacenter. They are connected via 10G Ethernet. Both Nexus cores are running OSPF between them. Below are their configs:Nexus 1:interface Vlan10 no ip redirects ip address 10.0.0.2/22 ip router ospf 3900 area...
We got this sorted out. Basically no physical changes were needed and we were able to leave the MPLS terminated to the 7K. We provided the local IP address of the CUBE to our SIP provider. The key is that the CUBE is able to route to the provider's S...
Cisco states on their website that the module is hot-swappable. I am just trying to find out if the switch requires a reboot to pass traffic on the ports. That kind of goes against the whole "hot-swappable" functionality. I guess my next step is to ...
Ok. The ID's were set based on location. At this point, we only have 1 process running per switch, but if we had multiple processes running I could see that matching the ID's would be easier to manage. Thanks for your help.
You could also try DESI label program. It has a bunch of built-in templates based on phone model. Program can be downloaded for free from here:http://labels.desi.com/info-exec/display/downloads
