Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I see the SX80 supports sound reinforcement (PA) natively. I'm looking to take this approach but in a "combined room" scenario.Current deployment:2 RoomsRoom 1 - SX80, Crestron 16x16, DSPRoom 2 - SX80There is an IR sensor that detects a movable wall...
I'm not a wireless expert by any means, but I would think based on the document this should be a simple initial configuration.
Going through the document 1815T Deployment Guide it says connect to router and then plug in to LAN3 and go to 10.0.0.1. ...
I am trying to set up some 7925 phones and was going to set up the WLAN via BDU. When the phone is powered on, it grabs the wlandefault.xml. However, after it grabs it, the settings are not what was configured in the BDU. I have saved as default v...
Understood and that's what the document says, however, we have had this exact same issue on the 8 we have tried.
Guessing I will need to open a TAC case.
