Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,
I am trying to establish the connection between 6880VSS pair and 6800IA using this SFP+fiber cable (SFP-10G-AOC10M) but the interface does not come up. I used a separate 10G SFP and separate fiber cable and it works fine. My 6880 version is...
I am trying to get the exact model of our FWs in the remote location and can't confirm if it is x model using show version. Anything specific that I should look at from the show version output?
Hi Guys! Trying to establish this VPN connection to our new client but the client refuse to provide public IP and our policy disallows routing to a private subnet. So what I did was configured a one to one NAT so that any traffic destined to the clie...
Hi Guys, Anyone who can help me verify if this setup will not have any issues? 4500-X G1/1 ---------------------------------------Non-Cisco Devicespeed nonegotiate Speed 1000/duplex full
Guys, I just need some clarification on the use of the bgp weight attribute. Let us say I have this setup. If both R1 and R2 are receiving the same set of routes from R3-R6, can I use weight attribute to influence the received routes so that R1 will ...
Hi Aaron,Thanks for your response. I am moving the connection from the existing 3750SW to the 4500X switch but I don't want to involve the team that manages the non-cisco device. The existing 3750 has the interface set to 1000/full, the problem with ...
Hi, Thanks for your reply. The routers have selected a better path for the routes that is why I wanted to know why these metrics were not selected. My question here is, will the metric from the router eigrp command be added on the route map metrics?
