Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am needing a solution for a small branch office with WIFI, VPN, POE, VOIP W/QOS, min 8, 10/100 ethernet ports with POE, and can use DSL or Cable as the primary ISP. I was looking at the 871, but I am not sure if this is what we need. Any help poi...
Clients are having problems roaming between controllers when running the CCA Client. They are unable to pass traffic but do have a valid IP address. Once the client returns back to the originating/local controller they are again able to pass traffi...
So is it safe to say that the Meraki go AP that I jut purchased will need to be returned? I have an existing MX60 and a MR16. I was just trying to add-on an outdoor AP for my area and I guess this was not the right choice. Please correct me if I a...
Thanks for the fast reply. The 871 looked like the best fit, I just wanted to make sure. How scaleable is it, we may need to add up to a total of 12 connections, with up to 8 phones. I know it only has 2 POE ports, I should be able to add an addit...
I have ran into this issue only on 1 controller on 1 of my 5 Wism's. There are 4 listed bugs on this(CSCsh35306,CSCsh48977, CSCsh50527, CSCsh50966) All dealing with ARP issues that make the controller inaccessable from the IP network. The only acc...
What selection are you using for the system time? Verify that the time is synced between both the controllers and the machine you are runing the upgrade tool from. I have used the V2.01 tool and did not have any major problems until my PC became ou...
This is fixed by following:From the WCS:Click on Configure: Controllers Click on the box next to the IP address to select all controllers. On the top right of the screen select the SAVE CONFIG TO FLASH and click GO.When this is complete the do the fo...
