Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, According to cisco DX series Administration guide the video stream will be transmitted as non secure and even if the both devices are secure, the encrypted lock icon is not displayed for video calls. http://www.cisco.com/c/en/us/td/docs/voice_ip...
Dear all, I am using CUCM v9.1.2 with VCS-C/VCS-E (X8.2.2) for remote and Mobile access.As Software, I am using jabber 10.6.0 for Android. I noticed after a short time (5 min) the Jabber client unregister from the CUCM without showing any message on ...
Dear all, I am using CUCM v9.1.2 with VCS-C/VCS-E (X8.2.2) for remote and Mobile access.As Software, I am using jabber 10.6.0 for Android. I noticed after a short time (5 min) the Jabber client unregister from the CUCM without showing any message on ...
Hey all,I am using the following topology:Video Endpoint (Public IP) <--(H323)-->cisco VCS-Exp(v7.2)<---SIP TLS---> cisco VCS-control(v7.2)<--H323 -> AA/MCU (cisco 8710)The video call was initiated from a Public VC endpoint using H323 protocol to ou...
Hi I am using cisco jabber video for telepresnece version 4.6 client with lenovo T420. P2P video call with the enbeded camera works fine. however during a conference call the Jabber client does not send the video stream and the camera is no...
Hi, I changed the refresh timer on all VCS-C and VC-E included in this call but in vain. The call was disconnected after 60min10sec with the disconnection reason (Egress disconnected call saying "Gave up retrying to send a re-INVITE"), see attached.I...
Hi Martin, As stated before the topology used is as flowing:Public Video End-device (Internet)<--(H323)-->cisco VCS-Exp(v7.2)<---SIP TLS---> cisco VCS-control(v7.2)<--H323 -> AA/MCU (cisco 8710). All traversal communications between VCS and VCS-Expre...
Hi Ayodeji, First of all thanks for your prompt reply I changed the session refresh interval to the maximum time allowed 7200 but in vain. Should I set the same timer value in all VCS oe VCS-E ? or just the one responsible of the disconnection? Best...
Hi Andy,
do you have resolved the problem? I have the same issue with TX9000 (version TX6.1.2) connected to CUCM v9.1.2. The call is also dropped direct after the connection:
2014-05-22 14:47:19: INFO Main Video negotiated Frame Rate is 30fps.
...
