Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Team,I have one Cisco switch 4506 series (Cisco WS-C4506-E) chassis switch. Suddenly my IP phones are stop working but data is working fine. So I have checked and found my ip phones are not powering on means my one of module POE stops working. I have...
What is WCCP and how we configure in Cisco Switch 4500 ISO version 12.2(31)SGA8 ? Which ISO version will support to configure WCCP?And Is there any possibility to use Extended Access list or Named access list to configure WCCP.I have Cisco switch 450...
Hi,Can any one explaine me why we are using maximum-paths commnd in EIGRP. What is the actual use. If i use what will happen and what will effect.?I know this is use for Load balancing purpose but how EIGRP do the load balancing.In which condition i ...
Team,Can any one tell me what is maximum segment size and why we use and how can we configure in cisco decive and which device(switch or Router).RegardsPrashant
Hi Aman,Thanks for the reply but i have replaced the faulty module with new one module and now its under control.I just want to know root cause or problem and what should i do to in future it will happen again. And i am trying to use the commndCORE_...
Hi Milan,I got my answer. i have tried to open your link but its not working. Can you share me the that document.And can you share any document which have full document of BGP including MPLS also from A to Z.RegardsPrashant.
Hi Alain,Thanks for your help. Now i got it the answer. I have tested in GNS3 lab and found it.But when i try in our L3 4500 Switch, it is not showing. Even though i have tried in 2600 router but no luck.There is any reson to not showing.And one more...
Hi,Will you elaborate me pls. I little bit confuse. I have some query here.Multihop: I think we use Multihop when we have two link connection otherwise Mutihop is not required. Pls let me know if i m worng.Suppose we have single connection then what ...
Hi Team,Thanks for your help. Now the issue has been resolved. I did not put the VTP password because of L2 switch is not updating the Vlan data base form L3 core switch.RegardsPrashant
