Hi all, I tried to upgrade IOS on WS-C2960G-24TC-L  from c2960-lanbasek9-mz.150-2.SE10 to c2960s-universalk9-mz.150-2.SE10. For some reason the boot failed and generated the following error: Loading "flash:c2960s-universalk9-mz.150-2.SE10.bin"...Bootable image segment 1 address range [0x2000000, 0x3245d58] not in range [0x0, 0x317fffc]. Error loading "flash:c2960s-universalk9-mz.150-2.SE10.bin" Interrupt within 5 seconds to abort boot process. I thought c2960s-universalk9-mz.150-2.SE10 shoudl work fine on C2960G but it didn't even boot up. It is the same version but different binary. Anyone can advise about the compatibility please? Thank you in advance. Regards Said ... View more

Hi, I was configuring NAT onto the following interface (router Cisco 881) interface Dialer0 ip address negotiated ip mtu 1492 ip virtual-reassembly encapsulation ppp load-interval 30 dialer pool 1 dialer-group 1 but everytime i enter the "ip nat outside", the dialer0 no longer pingable. Anything missed? Seems that i only have this difficulties on PPPoA, but PPPoE works fine. I have tried all kind of NAT (static NAT, overload), and weren't working. Below is the config of atm0 interface. interface ATM0 no ip address ip mtu 1492 no ip route-cache cef no ip route-cache load-interval 30 no atm ilmi-keepalive pvc 0/50   pppoe-client dial-pool-number 1 ! dsl operating-mode auto end Thanks in advance, Benny ... View more