About thomasjkuhn

thomasjkuhn · 11-10-2016

I am not experienced with the CUCM call manager in our test lab other than setting up some simple routes and modifying whatever was already configured on it by our previous engineer. This is not a live system, but just a test platform that is used f...

thomasjkuhn · 01-20-2015

Hello All,I will start off by saying that I am not a Cisco expert my any means, but I have asked a few Cisco engineers that I work with and have received conflicting information as to whether a Cisco switch such as a 3560 or 3750 is capable of handli...

thomasjkuhn · 01-20-2015

So for a 100Mbit port, the queue shape configuration for 2400bps would be: Switch(config-if)# srr-queue bandwidth shape 43690 0 0 0 104857600(100Mbit Port) / 2400 = 43690? Actually I just found you can set the port to 10Mbps, so the value coul...

thomasjkuhn · 01-20-2015

Ok, I just finished reading that section in the PDF manual. so, let me see if i understand... To clarify, I do not need to prioritize any packets. I just need FIFO. I would just need to configure the SSR per interface. the example given: Switch...

thomasjkuhn · 01-20-2015

I just took a look at the Catalyst 3750 Switch Configuration Guide, and it does discuss limiting the bandwidth of the egress interface. Unfortunatley it looks, as the previous pooster mentioned, like it has a low granularity.srr-queue bandwidth limi...

Member Since	‎01-20-2015 04:52 AM
Date Last Visited	‎04-28-2021 11:01 AM
Posts	5

User Statistics

User Activity

Adding VAD to a CUCM Trunk

Traffic Shaping on Switch - Is it supported and on which models?

So for a 100Mbit port, would

Ok,

I just took a look at the