Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Attempting to configure LACP from Nexus pair to Palo Alto firewall, and one of the 2 interfaces always goes into suspended status on the Nexus side. Physical status remains up, but non-functional. Nexus is set to active, PA set to passive, per PA rec...
Using ISE as Radius for device login. Have a primary/secondary server, both synced and apparently no issues. However, Radius authentication only works for a short time and only after we make a change and save it. We are using DUO MFA, and we get the ...
I have a DMVPN network with 4331 hub routers. Our HQ in Memphis has a hub on AT&T, and another on Lumen. Our New York hub is also a Lumen connection. All are 500Mb up/down. We have about 35 spokes around the US that peer to all 3 routers. BGP is the ...
Any help is greatly appreciated.We have a point-to-point circuit between Memphis and NY (Lumen E-Line Gigabit) that connects from our Nexus 9K to Lumen's metro ethernet switch on the Memphis end, and from our 4451X router to a Lumen switch at the NY ...
I have 2 Nx9Ks each with a VRF to an Internet provider. I want the 2 Nexus VRFs to advertise/reflect the routes they learn from their connected ISP to the other VRF over iBGP. I have followed the NX-OS configuration guide and cannot get this to work....
I kept playing with this and found an example - Configure VPC between two Cisco Nexus switches - Notes_Wiki - that hinted at the solution. My vpc ID was wrong, plus the spanning tree port type was set differently between the 2 Nexus switches. So now ...
Hi Mark, thanks for the quick reply. We've tried every setting of LACP in the Palo to no change. Palo said the problem is on the Nexus side. This should be so simple to fix, but I'm stumped here.BMac
