Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have configured tacacs in ASA 5520, it is working fine, I can login into ASA with tacacs credentials..authentication is successfull when tacacs server is unreachable Local authentication is also successfull.....But after that when Tacacs ser...
Hi,I have configured tacacs in ASA 5520, it is working fine, I can login into ASA with tacacs credentials..authentication is successfull when tacacs server is unreachable Local authentication is also successfull.....But after that when Tacacs server ...
Hi,I need to upgrade the software version of WLC to 7.0.235.3 with following primary and boot software: AIR-WLC4400-K9-7-0-235-0-ER.aesAIR-WLC4400-K9-7-0-235-0.aesAfter the upgrade how the APs connected to WLC will download the IOS of new Software v...
How can I enable Console port in 7206 vxr with NPE-G2 card installed, I need to use console from NPE G2 card.The device turns on and status is also UP and I can also telnet to the device but I am not able to access the device through console port...P...
Hi,If VPN is UP and all policy are fine..Try this once,Go to asa device management tab - >interface and there select your management interface as ur inside interface...I guess it will work..
Yeah I did tried the SET command and through it i have set IP address, Subnet, Gateway, tftp server IP and file....but as there is no tftpdnld and xmodem, whats next..???
