Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an open TAC case on this also....but it's taking longer than usual for them to get pertinent info back to me so figured I'd try here. I'm in the process of migrating from WCS to Prime Infrastructure 1.2 I've already sucessfully completed the...
I've got a number of 3502i's that I need to mount in a new classroom that does not have any ceiling (except the floor decking above). Ceiling is roughly 30-50' up. Contractors are going to run several 2" (or whatever we want) metal pipes from the c...
Anyone have any experience authenticating Cisco IP Phones (7942G & 7962G) via an 802.1x switchport using EAP-TLS with the Cisco installed MIC (manufacturers installed certificate)? What I'm trying to do is to authenticate the phone to our network vi...
We have forced auth codes setup on our CUCM v7.x cluster for all of our users. We are at the start of a migration from a Nortel Meridian 81c PBX to all CUCM. PSTN is connected to the Nortel PBX and we have a QSIG trunk setup between the Nortel and ...
I've got a 3825 running 12.4(24)T with a WLCM module installed in it. We are currently configuring this device for deployment (very soon!). I have some zone based firewall rules setup. Basically so our WCS server at our main campus can talk to the...
When the redirect happens on the switch, the packet is punted to the cpp for processing. The cpurpose does the rewrite and then kicks it back down a layer to be routed. This process isn't vrf aware and is sent back to the global vrf (at least it wa...
Check for bios updates or nic driver updates fron your pc vendor. The nic driver upon resume from sleep or hibernation should initiate a new eap session the re-authenticate under Windows in most conditions.
The switch is not getting a response back from the supplicant on the client. Is the supplicant enabled and configured on the client? Do you have may enabled as the next auth method? If not your client Wil fall back to no access depending on your ...
Finally got this working last evening! Not 100% sure exactly what I did but the restore was sucessful. I think it might have had something to do with making sure that NCS was not running when trying to restore the data. I didn't see any references...
Still no go with this. I've done "ncs db repairdb" on the PI1.2 VM and tried restoring the NCS backup, no go.Ended up doing an in-line upgrade on my original NCS appliance, that worked. Tried backing up the data from the VM I did the in-line upgade...
