Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,should be a fairly simple question but does UC560 WAN port support dot1q trunking back to switch? Can't see any doc on this.Aim is to run 3 VLAN's back to switch one for data,voice,SSL VPN for remote teleworker.Thanks,Joseph
Hi All,we have a base license ASA 5510, and been trying to get ICMP working to check that we're routing and not hitting any NAT translation. We have a VLAN280 setup to ISP for VPN link to remote site and another VLAN281 for internet access for intern...
Need QoS to help with packet loss.RSpan configured correctly? To recording ports? How is this configured to channels from switch?Run g711 codec between VoIP systems and recording servers.Sent from Cisco Technical Support iPad App
It highlights the access code field RED in the outgoing dial plan, when I tried changing this to new access code in all fields hit apply nothing stays RED.Sent from Cisco Technical Support iPad App
Was hoping that was the case. Makes the job a whole lot easier. it's trunking back to UC box from router so I may have to manually program the TFTP on phone to point to UC.However now QoS is an issue, no DTLS or MTP resource?
That's ok I looked into it SR520 looks like the teleworker router. Haven't used this but I'm wondering if that can terminate on the 1921 or does it have to connect back to UC540?Exploring all options none look easy. Was even thinking that SPA525G bui...
