Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have a couple of 8851 with 1 BEKEM module installed, and I have the problem the the BEKEM module is getting disconected and after a few seconds it conect again.My System version: 10.5.1.11901-1 and my SIP phone Firmware is sip88xx.10-2-1-16
Hello, I have a question on a Cisco AIR-LAP1242AG-A-K9 with LAP image it´s possible to load an Autonomous image?I have done it but with Access Points that had form factory an AP image change it to LAP and then return the original AP image, but on...
Hello.I’m installing a BE6000 8.6.2, and the Install disk of the Cisco Unified Comunication Mgr Unity Connection/BE/SME is damage can’t be read.Try to download it from Cisco Support but couldn´t find the file, only found Service Update, Recovery Disk...
