Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
.Jabber for Windows 9.2.1 Contact "Away" status doesn't show duration. I am wondereing if it is possible with Cisco Jabber client. Microsoft OCS client used to show.
All VoiP phones are set to use External Phone Mask 8666 XXXX. The router pattern for mobile calls also configured with following settingUse Calling Party's External Phone Number Mask. So when outbound calls are made destination phone see the actual D...
Hi Experts, We have one Publisher and one subscriber -Our phones are registered with Subscriber. CM Group has subscriber as the first CM and publisher as the second. During failover (I unplugged the subscriber) found that half the phones couldn't fai...
We have changed IP addressing of our VoIP phones from Public Range to Private 10.x.x.x. Our Main Site IP addresses change took place before I started so don't know if some configuration change was made on CUCM 6.1.3 to make it work. I changed the IP ...
We have changed IP addressing of our VoIP phones from Public Range to Private 10.x.x.x. Our Main Site IP addresses change took place before I started so don't know if some configuration change was made on CUCM 6.1.3 to make it work. I changed the IP ...
Hi Sriram,Thanks for all your help. I was able to prove it to Telco that the change is needed on their end with the help of the debug.Regards,Rakesh Mehta
Hi Sriram, Debug ISDN Q931shows that we allow the CLID to pass as it's .1.So when my phone was NOT SET to use external mask then debug showed that calling number is "four digi extn 2211" but the destination phone dispayed our reception number.2. When...
Hi Jonathan, Thanks for your response. We are not using mobile connect at all. I am just configuring phone to forward all calls to my Mobile / Cell Number and expecting to see CLID as either my desk phone or the CLID of phone which is trying to reach...
Hi Sriram,Thanks for you reply. Let me bring this to your attention that we have mixed enviornemnt as we have some tradtional phones and lot of them converted to VoIP.We have two gateways in place. One is mgcp and has 2 E1 trunks to PABX. PABX has 2 ...
