C60 touch panel 8" direct pair fails, for long time it displays Select Language page in the touch panel. Direct Pairing is ON and Network Port 2 is set to DirectParing Tried rebooting and resetting couple of time but no luck. SW - 7.1 Note: First time installation the touch controller was connected to codec via LAN and now i am trying to connect it directly to codec but paring is not happening. ... View more

We are going thru building power maintenance activity and my question is, is there any Cisco recommened or process or practicse for shutdown/startup the Telepresence devices and VCS, TCS, MUC. ... View more

After completing an videoconference meeting were MeetMe video bridge and audio bridges(Cisco Intercall or Meetingpalce) are merged, while ending the call only video call gets disconnect but audio call remains connected in the MCU, later if we dial same MeetMe bridge for some other meeting or from other endpoint the audio bridge remains connected. In TMS - Monitoring - Conference Control Center - In Participants Name it displays VCS is Connected. Work Around: End the Bridge manually in TMS. TANDBERG VCS's - Software version: X7.1 and X7.2.3 TANDBERG Codian MSE 8510's - Software version: 4.3 and 4.4 TANDBERG Codian ISDN GW 8321's - Software version: 2.2(1.86)P ... View more

Hi,           Can any one help me in connecting audio output cable (RCA connector) between C60 codec & Digital Sound Processor. Sincerely, Mahesh Kumar                              ... View more