Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am currently using Cisco 2602E access points in autonomous mode. We have used these for a couple of years with 2430V-R antenna. I believe this antenna is 2.4ghz only and I want to start supporting 5ghz. The 2602E is a dual band radio with 4 ant...
Hello everyone, thanks in advance for any help you can give me.I have a new site with a 6509 switch. It is connected back to my main site by two P2P layer two trunks. I have to trunk VLANs between the two sites for about six weeks until I get all ...
Hello,Thanks in advance for any help you can give. My company uses DMVPN all over the country to back haul small office traffic to Headquarters. We back haul all traffic. Corporate network and Internet traffic for Websense usage.I have a new site ...
I don't know if this problem is a ASA issue or other, just looking for opinions.I have a Corporate website where my users keep getting disconnected from. The admin of that website sent me this information in an email.....I've traced two sessions s...
I have two campuses. Both with a 6513 switch, both 6513s have multiple VLANs alerady created on them for different reasons. These two campuses are connected with a Metro Ethernet. The port that connects the two switches together is defined as a ...
Just to update this discussion............... The original config was correct. I simply had to have the ISP add route command to their router...ip route 180.7.185.0 255.255.255.0 192.168.0.32All is working now, thanks to everyone....
Here are two exact-route commands,,, one out to the Internet and one to the Corporate network.mxprt01#sho ip cef exact-route 180.7.185.221 8.8.8.8180.7.185.221 -> 8.8.8.8 => IP adj out of FastEthernet0/1, addr 192.168.0.1mxprt01#sho ip cef exact-r...
Sorry about the delay, I was changing some of the route statements on this router and cut my self off.... had to get them to power cycle. The spoke config is attached to the first comment in this question.Thanks
I don't know about the proxy server. This is a real difficult install. Foreign country , different language and language barriers. I don't have control of the ISP router. I only know that when they connected the router I shipped them the Tun...
