Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Any chance of enabling a LAN ONLY mode in the next UC320W firmware so that it does not have to be the gateway for the phone network?It's predecessor the SPA9000 had this capability and worked fine. I like the UC320W but don't want to use it as ...
Hello,About to purchase the UC320W and had a quick look at the online emulator.Plan to use with a single analogue trunk and also a SIP trunk. Is it possible to have a separate steering digit for the outside line, ie dial 8 for outside analogue trunk ...
Hello,I currently have a SPA9000/SPA400 on a vlan/subnet behind an existing non-cisco firewall / router. I am looking for more functionality and reliability and have acquired a UC520 which I plan to swap for the SPA combo.I have seen a document for p...
Hello,Have a SPA900 connected to a SPA400 with a single analogue line plugged into Port 1 of the SPA400.If we make a call through the SPA400 the person called hears a very choppy call like a very bad SIP call.Found the support document on choppy SPA4...
Hello,I have a SPA400 in place for years but was only using it for voicemail which worked great.Lately I needed to reconfigure it to work with a single analogue line plugged into Line 1. But the SPA400 showed the line as On-Hook with 0V (somethimes i...
Having the UC320W as the DHCP server for the voice VLAN isn't a problem but if we are not using the WAN connection on it then the UC320W isn't the gateway for the VoiP VLANSo how do I change the Voice VLAN gateway address to my actual router address ...
Hello Wendy,I can't see where I can set the gateway on the Voice VLAN to anything other than the UC320W, nor can I see how I can turn off DHCP for the Voice VLAN.and there is no option to set the WAN connection to none.Is there a doc to help setup th...
Hello Wendy,I don't want the UC320W to route anything and don't want to have to use the WAN port on the device at all.I just want it to be a phone system like the SPA9000 in LAN mode.Is this possible with current firmware does it always have to be th...
Hello Konradkon,I think I would be foolish to proceed any more with the UC520 you are right. CCA does not do what it says on the tin and ios knowledge is a must. Gonna go for a UC320W....much more SIP "LEGO DUPLO" style. I've heard good things abo...
