Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears,One of our customer is having a Cisco AIR-WLC2112-K9 , we purchased an AP AIR-CAP16021-C-K9 , based on the supplier recommendation ,As I understand , CAP16021x Series require a Wireless Controller with firmware 7.4.x and above where as Cisco 21...
The client has Cisco C2911-CME-SRST/K9-2911 Voice Bundle Currentlt they are having about 10 users/phone , but they would like to upgrade to support 50 users,As per the below link http://www.cisco.com/en/US/prod/collateral/modules/ps10598/ordering_gu...
Dear All, I have Cisco 1841 router running the below roles 1) SSL VPN Server 2) PPTP Server3) Site to Site Connection with Sonicwall routerI want the router to be configured a pptp client to internet vpn server (so that i will get a fixed publ...
I have 2 Cisco routers , 1841 and 2811 , I need to setup site to site VPN , but i dont now some how it just does not seems to be working , Find attached the Configuration along with the <----- 172.31.1.0/24----- DG:172.31.1.1>Cisco 2811<Dialer...
Dear All, I have configured SSL VPN on Cisco 1841 router running (1841 Software (C1841-ADVSECURITYK9-M), Version 12.4(15)T1) , I have PPPoe broadband connection and NAT is has been configured , i have below issues 1) From the portal i cannot access a...
Thanks Xie Yao , Appreciate your help , I have a small question , what if i want to port forwarding for one site of tunnel to a server connected by vpn tunnel.
Thanks Karsten, Now can you please help me atleast to get the SSL VPN Client working, is there a possibility of Teamviewer Session (If its not asking for too much)RegardsHasan Reza
Thanks for update (I was really desperately awaiting it), i have only 32 mb flash card hence i am using this IOS , anyways can please tell me if i need to make some acl rule changes to get this whole this to work , Or Suggest me some IOS , below is l...
Dear David First of all i cant express my happiness and gratitude , just for the fact that someone did answer , GOD BLESS .Well shall do a packet capture at the client end using wireshark and then send the entire capture , i tried doing the below at ...
