Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a client using IPC over WIFI. It's our own WLC in a hospital.The IP Communicator has one-way-audio, and I think it is because the IPC is registered back at the Call Manager with the address of the SUBSCRIBER server. I can't figure out how that...
I finally got the SFTP server to accept my Publisher login for Disaster Recovery backup, however after each backup the backup does not seem to quit. The monitor says the backup was 100% successful; the files all appear to be present on the SFTP serve...
Since we upgraded CallManagers to 4.2(3)SR3a, our ATAs don't hold calls. Sometimed 2 minutes, sometimes 30 minutes, but the call WILL get dropped with a 'Temp Fail' message on the Desk Phone and a CDR disconnect code of 41 (Temporary Failure).No rout...
In evaluating the Manager and Assistance feature of CallManager 4.2(3), I configured phones for the test that place a DND (Do Not Disturb) logo on the Manager's phone. Now I want to re-use th phone but can't seem to remove this graphic from the 7940'...
We have a VG224 handling some analog devices (phones/faxes/paging) and notice that the only time QoS is not acceptable is when this device is at either end of a call. Auto QOS is enabled on switchports (same switch/vlan as the Call Manager) and on th...
We have the same issue not being able to use ACS and WCS.I tried to d/l that patch: 5-0-0-21-7.tar.gpg, but the download comes as 5-0-0-21-7.tar.tar I tried renaming the file as a .gpg, but that does not work either. Just locks up the Web console...
I'm trying to use TACACS in our WCS/WLCs to authenticate to our ACS 5 server with no luck either. I can't find any step-by-step docs anywhere. We upgraded the WCS to verison 6.0.132.0 in hopes this would help, but we are still stuck.Also tried upgra...
but this isn't available on the Downloads site yet. I don't see any of those exact versions.I am new to bug monitoring...would this be considered an Engineering release or would it be a standard release?
I installed and configured FreeSSHd as an administrator, and set the service to run as that users as the settings don't seem to be transparent between users.At first I thought the problem of DRS not quitting was because I was testing with an interact...
I tried to configure some other ones but kept hitting a wall. Cisco recommended (but doesn't support, obviously) the FreeSSHd application. I figures that one should be compabible.Any other SFTP suggestions?
