About Mike Hogenauer

Mike Hogenauer · 09-20-2015

Hi, I need help with a DMZ on our edge network and a ton of web servers that are in the DMZ from two different /24 subnets..We have 2 x /24 public subnets that are routed to us from our ISP (63.241.163.0 and 63.241.172.0). Our ISP routes them to our ...

Mike Hogenauer · 05-21-2015

Hi, I have several remote sites and two main Datacenters. Each main DC is connected via a METRO-E Wan, Datacenter A routes traffic for 10.1.0.0/16. Until now, DC A was the only DC that has a link into our provider MPLS Cloud, all remote sites connect...

Mike Hogenauer · 02-21-2015

Afternoon – I’m looking for the best way to advertise two separate datacenters subnets into our private BGP / MPLS cloud. We have two main datacenters one advertises the summary router of 10.1.0.0/16. The other datacenter advertises the subnet 10.2.0...

Mike Hogenauer · 01-09-2015

Hi,This is my first time rolling out a next platform. We have two 7ks that vPC to two downstream 5Ks and each 5K has about 10 x 2K’s off each 5K as TOR for VMware and Hyper-V servers.If I setup a single sever as an access port I have no issues. We’re...

Mike Hogenauer · 11-12-2014

I have a single Spoke (for now) that I’m testing with, I’m running Phase 2 DMVPN and I have two tunnels built on the Spoke router. Tunnel 10 goes to DC1 and Tunnel 20 goes to DC2.The Spoke router is sitting behind a normal SoHo Linksys routers and th...

Mike Hogenauer · 09-21-2015

No - you're right Jon.Thanks for jumping in on this one. I'm going to just route the VLAN 172 IP space to the outside IP of the edge firewall and then NAT from there. I was hoping there was a better way but I think you're right - for what i'm trying ...

Mike Hogenauer · 09-20-2015

Hi Jon, Thanks for the reply. I too am not a fan of using secondary interfaces. yes, the other range is the 172 Vlan, I see where my post was confusing. Right now the only way i see this working is if I route the 172Vlan to the outside interface of t...

Mike Hogenauer · 05-26-2015

Yes - I have redistributed the routes and tied that to a route map for control Mike

Mike Hogenauer · 05-25-2015

Each DC has its own summary - not both summaries to null 0. DC A has a route to null 0 for its local and the same with DC B. Each DC has does however have a summary route for the other DC in its routing table which it learned from EIGRP. So based on ...

Mike Hogenauer · 05-22-2015

Hi Jon, Sorry if my ordinal post was unclear. DC A and DC B are connected via WAN. They are both in the same EIRGP AS (100).Under the BGP process, for DC A, I do have a summary address of 10.1.0.0/16. For DC B, under the BGP process I have the summar...

Member Since	‎02-13-2013 09:24 PM
Date Last Visited	‎06-19-2018 10:50 PM
Posts	34

User Statistics

User Activity

Configure Web servers in DMZ 2 X public subnets

AS_PATH PREPEND into MPLS Cloud - Redundancy

Advertise two different Data center summary routes into same BGP MPLS Cloud.

Configure ESX1 and Hyper-V to Nexus 2K Help

VLAN behind DMVPN cannot get to Internet

No - you're right Jon.Thanks

Hi Jon, Thanks for the reply.

Yes - I have redistributed

Each DC has its own summary -

Hi Jon, Sorry if my ordinal