Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What is the best option to connect two 6500 switches through 10Gig links using Fibers, either using MCP or Single Mode Fiber?Any issues with a direct single mode fiber b/w the two ends?
I like to create a L3 ether-channel b/w VSS switch (using MEC) and 7200 router. I like to run EIGRP on it. My router version does not support NSF on my router. router version is 12.4(23). Should I expect any downtime while one of chassis is going dow...
I faced a similar issue but one of the switches involved was vtp client and it needed vlans from the other switch (which was server). Just moved the vtp client to transparent, created native vlan locally, made it vtp client again and all worked as de...
As some one has mentioned that you don't need "ip helper-address 172.16.30.1" under vlan 300, please take this line out. I assume clients are MS windows based then it should be the issue with the DHCP server. Make sure the "DCHP server"service is up...
