Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,
I am having issues with Prime 3.0. I have enabled AVC on few ISR 4331 routers, I can see application utilization graphs on Service Assurance dashboard, however the problem is when I click on application graph it will redirect to Perf...
Hi Guys,I am bit confuse with storm control support on Nexus 5K NXOS 6.x. I have notices the storm control is only available only on port channel interface. However, in earlier version 5.x it can be enable on physical interface level as well.http://w...
Hi Guys, We are facing DHCP relay issue on 4500X (VSS) core switch. The topology is simple, all the access switches has been connected to core on MEC ether channel (L2 trunk, no VLAN/VTP pruning). The DHCP server resided in data center on VM. FYI, It...
Hi All,I am trying to configure Fortigate firewall for device authentication through TACACS+ using Cisco ACS 5.2. I was wondering if any one had an experience to worked on this scenario. I am looking for authorization command attibute to grant admin ...
Hi,I am working on ASA and TMG proxy server design and need your expert advice. The setup is <TMG> ||<Internet><ASA><CORE SW><LAN/WLAN> | <DMZ>I am placi...
Hi Muthu, Thanks for your reply. I am bit confused with this explanation in documentation.I am referring to NXOS 6.x layer 2 switch configuration guide. Guidelines and Limitations for Traffic Storm Control When configuring the traffic storm control ...
Hi Rajeesh, Thanks for your reply. you mean service DHCP enable on core switch ? yes it is enabled.sorry I don't have topology at this time. Regards,Asad Hasan
Hi Guys,I am working on a scenario where I need to authenticate WLC users with ACS 5.2 using TACACS.We have two types of users Network Admin (with full access) and Network Technicians (with read only access).I have reviewed the below post, however ju...
