Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am upgrading a active/standby pair of asas 5520's from 8.4.1 to 8.4.5. I am wondering if there is anything i need to be careful of. I do use a lot of Nat policys and i have had issues with 8.4.1 and proxy arp so i hard coded alot of my nat ip...
Hello, I am getting the following error:%MLSCEF-SP-2-FIB_SSRAM_WRITE_INCONSISTENCY:FIB SSRAM Mismatch for Index: 98305 Expected: 4000 , Hardware: B004000My IOSIOS (tm) s222_rp Software (s222_rp-IPSERVICESK9_WAN-M), Version 12.2(18)SXF17b, RELEASE ...
Hello I am currently replacing my Sonicwalls with Cisco ASA5520's. One of my VPN tunnels currently functioning on the Sonicwall Requires a IKE Peer ID be programmed, I tried programing the ASA without one but the tunnel will not stay established. Ple...
Hello All,I am in need of some asistance, I have searched for days one forums and Google and am unable to find a sample config that doesnt use autoqos.I need to enable QOS on a 6513 that i am using as a access switch.( loaded with WS-X6148-45AF). I ...
Hello All,I have a VPN tunnel that has been working fine for months, last week it stoped processing data, i bounced the tunnel and it came back online. then again today it has happened again, this time i can see that the packets are encapsulation but...
The tunnel refreshed after the the keys refreshed and brought it back online. still unsure why it did what it did. Btw, i have two different sa's on the same tunnel one of the sa's is fine and never failed the other sa is the one having issues.any in...
I had to hardboot the entire switch, Power supplys now showing correct.system power redundancy mode = redundantsystem power total = 3830.40 Watts (91.20 Amps @ 42V)system power used = 1735.86 Watts (41.33 Amps @ 42V)system power available =...
I called tac, and then reliaze that the sup2's didnt have enough memory to support the IOS. I have memory on order and once upgraded It should load fine.Thanks for you help though Eugune.Regards,Brad
