Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Created a Public Distribution List in Unity and added members to the group, let's call it 1111If you call 1111 it goes to a default message, and want to change it, but we cannot figure out the password/pin. I've tried the default and tried the owne...
We have two sites with the same subnet, 192.168.1.x /24. Want to create a point to point VPN between the two. However the side we control has a UC560 in place. The only traffic needed over this VPN is from a server, 192.168.1.250Now on an ASA I kn...
I have a setup using an ASA 5510 8.2(2). In the DMZ (192.168.12.x) there is a server, switch and multiple cameras for surveillance of the site. In the Inside (140.152.25.x) are the pcs that can run the client software to view the video feed, or it ca...
I can not seem to get this to work, can someone see an error on the cisco side? My thought is it's a Microsoft issue but would like to have my config reviewed anyway. Here is my config:version 12.4service timestamps debug datetime msecservice timesta...
Torsten, Contact Cisco SMB support and request a return of the SA. You should get your money back that you could put towards the ISA series and transfer smartnet. A pain but at least you can recoup the money. The cost of the ISA was almost equal for...
Just an FYI the problem was that there is a CSC module on the ASA. In the config was the command "csc fail-open" under a global-glass. This was allowing the return traffic to come back un-inspected, which prompted the "TCP closed by inspection" err...
sh service-policy inspect httpGlobal policy: Service-policy: global_policy Class-map: inspection_default Inspect: http, packet 1510005, drop 0, reset-drop 0I'm new to this ASA, I've questioned that access list myself, but am not positive wh...
Thanks for the link Calvin.I actually got it to work by just old fashion trial and error. Turned out to be two things:Microsoft 2008 R2 NPS>Policies>Network Policies>" Wireless Policy I created">Authentication Methods.... CHAP had to be enabled.Mi...
