Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am getting the new Cisco 2921/K9 router, which comes by default with 3 Integrated 10/100/1000 Ethernet ports.I have Comcast Cable as the ISP, so can I connect the ISP RJ45 Copper cable directly to one of the integrated ports or do I have to buy ano...
We have two 6509 switches, using VSS. When I do sh proc cpu, it shows 70% to 90% utilization, which is too high I think for that kind of switch.If anyone can help me in finding out, why it's utilizing that heavy process, appreciate it.
I have a .pcf file that I used with cisco vpn client, which connects successfully. But as Cisco VPN Client does not support x64 bit OS, I am using the Shrew Soft Vpn client, installed on x64 bit Windows 7 OS, and imported the .pcf file, connects succ...
Hi Julio: I am having the same issue, but after running the command ssl encryption aes256-sha1 des-sha1 3des-sha1, it didn't fix my issue.I did debug http, and it gives me the following message:sec/act(config)# listen: Received HTTP request.Started h...
The drops does not increase on the vlan interface as shown belowInput queue: 0/75/1874015/0 (size/max/drops/flushes); Total output drops: 0It stays at the same number, please let me know, what are the next steps to look into.
When I run, sh int command on one of the WAN interfaces I get the following message, is that an issue or notInput queue: 0/75/1874015/0 (size/max/drops/flushes); Total output drops: 0
