Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.I have a 1760 with a 1 ADSL port, the carrier have a problem in the network and when carrier resolved the problem my internet connection is not restored, if I connect the carrier modem (2wire) the internet connection work, I changed the spliter, c...
Hi.I need to configure a VPN L2L in a PIX firewall version 6.3, my problem is that the remote point must be to a domain name rather than an IP address, I need help with a example configuration file, steps and requirements.Thanks.
Hi allI have a CCME version 4 in a 2811, I need establish a call code to limit the access to the LD for users.I know that the CCM have a FAC for this function, but I dont know like does this in CCME.
Hi all.I have a router 1841 with 2 connections to Internet (V.35 and Fastethernet-Dialer-PPPoE)with 2 ISP's, the V.35 connection is for VPN clients and L2L VPN, and the other (Dialer) for navigation, I have configured 2 default static routes, but whe...
Hi all.I have a situation with volume calls.1.- When the calls are originated in the PSTN to the IP Phones, the volume is ok in both sites.2.- When the calls is originated in the IP Phones to the PSTN, the person in the PSTN listens very low.I try to...
Hi.I searched the firmware on the TAC website, I have not found any firmware, can you tell me more about it or any document that showing the updated process and the file needed to downloadthanks
thanks but I don't found the example configuration that I need, most of the examples of IPsec are for version 7 and the examples do not include the configuration of the domain name instead of the remote peer IP.
I have configure COR in the CCME, but I need to establish a code that can give to the user to make salient calls of LD.is correct, The code I am trying to configure is for outbound call restriction.Something like FAC (Force Access Code) in CM
Hi RickI configure PBR and delete the serial default route, the VPN clients establish connection to the VPN-Router, but the traffic between the private networks (LAN and VPN Clients) is not established, if I add the default route by the serial interf...
Hi PaoloI do not have much experience in this, do you know some docuemnto that describes the configuration, and if you have some commentary of as to use it for my case?
