Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
we are running ASR9K as BNG for PPPoE termination, when configuring the BNG to use the Loopback for the Radius outgoing packets. it ignores the command and use the outgoing Ip address to reach the radius we are running IOS XR 4.2.3 radiu...
Hi,
unfortuantely i discovred that the command " remote circuit id 200" isn't available under the EVC Xconnect configuration on ASR900 routers.
could you please try the second solution and inform u, by only use the below command under the ASR...
Hello,
You can establish the PW between the two attachment circuits with mismatched VLAN tags using the command under the ASR900 EVC
remote circuit id 101
As below:
ASR9000:
l2vpn
pw-class gia1 encapsulation mpls protocol ldp tr...
Hello, actually the labels are here but it has the value of IMPLICIT_NULL check the output of the show ip bgp x.x.x.x R1#sh ip bgp 33.33.33.33BGP routing table entry for 33.33.33.33/32, version 18Paths: (1 available, best #1, table default) Not adv...
Hello, AToM uses one MPLS label to identify the AToM VCs (VC label). Therefore it needs a protocol to signal this VC label ( which is LDP for Cisco ATOM ) "Martini Draft "and due to that the two PE routers mostly aren't directly connected it uses Tar...
