Hi, I have a site-to-site vpn configured in Cisco 881 Router using certificates.  The current certificate is going to end and I have configured new keys, trustpoint and a new Certificate send by the CA.  Currently the two trustpoint and certificate are configured into the router, but VPN is using the old certicate. I want to choose the new certificate to be using by the ipsec tunnel. Is it possible? In ASA FW I think that is possible to choose the certificate that you want to use, but, in IOS router I can't see how do it.  How could I test the new certificate into the VPN site to site to confirm that it works fine? Regards ... View more

Hi,   It is neccesary configure IPEP if we dont want posture into vpn remote users?   I know that IPEP works with Cisco ASA for VPN posture assessment , so the question is what about VPN concentrator StoneGate ? Has anyone tested IPEP inline posture with Stonegate VPN concentrator or other different that Cisco ASA? Regards   ... View more

does N6001P-4FEX-10GT bundle include any Nexus 2000? Thanks ... View more

I am configuring a ISA570 Firewall and I have problems to apply NAT policies in a VPN tunnel. I want NAT to traslate local network to public ip address. I can't select "Apply NAT Policies" (check is off) into vpn--> site to site --> ipsec policies -- advanced settings Thanks ... View more

We have one Air-ant2430V-R antenna and one AIR-AP1242G-E-K9 ANT-2430V-R has 3 RP-TNC connectors and AIR-AP1242G-E-K9 has two. Could I connect it? Will it Work? Thanks ... View more

The scenario is the next one: Ten access points and one WLSE Express. One is configured as WDS with a priority of 254, other access point as WDS with a priority of 128, and the other as Infrastructure AP's. The infrastructure AP's are authenticating to the WDS AP with the RADIUS Server of a WLSE Express. There are two SSID's configured in each AP each one in a different VLAN. All the clients are authenticating with an IAS configured in a W2K3 machine with an Active Directory. There is configured a RADIUS Server in the WDS AP's, and the WLCCP authentication server for the clients points to an AAA group, also configured in these AP's, so I think that it is not possible authenticate to more than one RADIUS Server when you are using WDS (I can do this if I do not use WDS because I use the AAA group server configured in each SSID, but in a WDS environment the infrastructure AP do not use the RADIUS server configured in the SSID but the RADIUS server of the WDS set up). So every user can authenticate in all the SSID's, the problem is that one of the SSID's is set up for guests and we want to make some access lists with a firewall to filter the access of every user. The question will be: Can we configure two or more RADIUS Servers when I am using WDS to authenticate users in two SSID's? Maybe the solution to the problem is to configure the IAS Server correctly but I think that this server does not know the SSID of the user that is authenticating. Thanks in advance ... View more

AIR-BR1310G-A-K9-R, this device incorporates two RP-TNC connectors for external antenna. has it an integrated antenna too, like the AIR-BR1310G-A-K9? ... View more