Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am using a CCM 3.1.3 and a ATA-186 with SCCP software.And i am using just 1 port of the ATA-186.The first line is working fine but the second gets an auto-registered DN from the CCM. I want to disable this line because i don't use it.Does anyone kn...
Hi, I experienced the same thing with an BRI port.I found that the dial-peers were in a "down" state, because of the ISDN status is down.You can use the following command to solve this."no dial-peer outbound status-check pots"Kind Regards,Mario
Hello,I got the same situation and it is working fine on ICD.You need to check which host you defined in the services config.This should be the server where the ICD is running and not the callmanager.Good luck,Mario
HI,I've been searching on CCO and as far as i can found that there is no support for the "backup load" command on an sub-interface which is on a frame-relay encapsulation.See the following URL:http://www.cisco.com/en/US/customer/tech/tk713/tk237/tech...
Hi,I think that you should configure the backup commands on your sub-interface.Be aware that you are using fram-relay and when the PVC is down your interface could be up. So the router won't dailout.Regards,Mario
