Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
On SG500, SG300 and SG200 series switches, SNMP is painfully slow.When I snmpwalk the switch, it dumps about 30 to 40 entries, pauses for a second, then dumps another 30-40 entries, pauses for a second, etc.Multiple snmpget requests cause the snmpget...
Wireless LAN controller Application Visibility and Control question.How can I add an entire application group at once instead of having to add every single application name under that group?I want to mark all packets that fall under "voice-and-video"...
Using an SRP251W-U firmware 1.2.5I have two ports forwarded, one is a straight forward for port 22 to the local LAN server. The other is a port forward for external port 81 to internal port 80 on the same LAN server.Using Network Setup -> Firewall -...
I upgraded our 509G phones from 7.5.2b to 7.5.4 and immediately noticed that the CallerID CNAM on inbound calls is truncated more than it was with the older firmware.With 7.5.2b an incoming call would show:From: SOME CALLER IDWith 7.5.4 an incoming c...
I need to setup the following:ALL traffic FROM internal IP of 10.0.0.1 needs to be seen on the internet as the public IP of 204.0.0.1ONLY ports 80 and 443 FROM 204.0.0.1 need to be sent to the internal IP of 10.0.0.1I've tried NAT with route maps, bu...
Layer 2It's now happening on a SG500-28P as well, I happened to catch it on the 28P as it's quite sporadic when it happens. I am requesting snmp traffic metrics for 26 ports via snmpget, those reqeusts get sent at the same time. All of the requests...
I'm not specifically walking the entire tree, but I see the same symptoms when I do walk the entire tree.This is on a set of 2 SG500-52P's stacked as a single manageable unit. I'm walking the PoE power usage tree in order to obtain the total PoE pow...
The same symptoms seem to exist when I change the first rule as you suggested.Here's just the rules I have now:Priority 1 - Source: x,x,x,x - Dest 192.168.0.253/255.255.255.0 - Proto ANY - Source Port ANY - Dest Port 80 - PERMITPriority 2 - Source: 0...
