Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was wondering if anyone has a baseline syslog message configuration. I know how to setup syslog and understand the logging levels, but I am looking to capture mostly warnings with some informational messages being elevated to warning status (exampl...
I have an interesting problem that I am looking for some advice on. I recently replaced an ASA5510 with an ASA5525 on site. The LAN interface on the ASA plugs into a linux transparent proxy server. Over the last few weeks since the ASA replacement...
I currently have CM8.5 running with a SIP provider trunk out to the internet. It is running via CUBE that is on a DMZ. The firewall is an ASA and it is doing SIP inspection, so the payload is being NAT'd along with the ip headers. We are replacing...
Has anyone seen anything similar to this with basic call parking? Any help is greatly appreciated.CME version 8.8Phone: CP8941When the user parks a call, it parks but does not display the extension it is being parked to (Call Parked On: XXXX). tele...
The autonegotiation going back and forth before settling on 1000/full sucks, but I cannot manually set the speed/duplex on the linux proxy server - its a limitation of the software. The proxy software vendor of course blames the ASA.The difficult pa...
good luck finding a non Cisco solution, same thing is happening on juniper, same thing is happening on sonicwall, same thing is happening on fortinet. this is oracles problem, I'm sure all the Dev teams are working to fix software for the new securit...
I have not tested it yet. I wasn't sure exactly what it would do with the TTL of 1, but didn't know if anyone else had tried it. Sent from Cisco Technical Support iPad App
