Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,I have a question regarding EIGRP.I have an ASA and two 3750 switches connected as follows ASA---eth----Cat3750_1----eth----Cat3750_2All of them are configured for eigrp 100. Routes are being exchanged between ASA and Cat3750_1 and betwe...
Hi Everyone,I have a question.I have ASA1 and ASA2 connected over a private IP cloud and two hosts behind each of the ASAs.The tunnel is up and I can ping from host1 which is behind ASA1 host2 which is behind ASA2 over the VPN tunnel.When I do show c...
Hi Everyone!I have a question about NAT on ASA firewall. I have a host coming from outside with IP address 10.0.0.10 to my inside network host with IP address 192.168.0.10 I need outside host's IP address(10.0.0.10) to be translated to 192.168.0.11 w...
Hello Everyone!I have a question about L2L VPN and NAT. Can I setup VPN tunnel between two ASAs or routers using NAT translation of inside private IP addresses to the single Public IP address on the outside interface and then implement crypto interes...
Hi Alex, I was meaning is it possible to separate out Public from Private in the same access interface so that Public Pools would be in the global, but Private in the VRF when I use BNG as my DHCP Server. In my configuration when I put Access interfa...
Thank you Varun.I did as you said, and I didn't even need nat (inside,outside) source static ASA2_LAN ASA2_LAN destination static ASA1_LAN ASA1_LANfor packets coming from the remote ASA to be translated properly.I did only object network outside_netw...
