Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In a CallManager Express / Unity Express environment, we have a problem where certain users cannot access Voiceview Express. This issue is restricted to users that have mailboxes set to autologin without PIN from the subscriber's extension. If pinl...
I have a script setup for a Unity AA that has the user press 1, 2 or 3 to be transferred to various departments. One department has a 7-digit local phone number, and the AA can successfully dial out to contact that department. Another department ha...
I've inherited our current WLAN that consists of two identically configured 1121 APs in separate buildings. Authentication is WPA-TKIP PSK that requires manual configuration of all devices. Guest access is handled through a separate VLAN that has A...
I'm trying to set up a site to site PIX VPN to an IP address that isn't the exact IP address of the outside interface. I get the following error in the syslog and the VPN cannot connect:Message=<163>Oct 21 2008 21:14:26: %PIX-3-106011: Deny inbound ...
Hi Carlo. I wasn't able to try your last suggestion -- I've been out of the office for the past week and will be out again this week as well. While I'm out I did hire a contractor to attempt to resolve the solution. They'll be coming in to take a...
That's odd that it would say that. The number is definitely correct, and can successfully be dialed directly. In addition, if accessing the AA through its internal extension, the outbound call connects successfully. It's only when an outside calle...
Carlo, Thanks again for the response. After adding the dial-peer, the result was the same. debug isdn q931 output is as follows:Cisco2821#Cisco2821#sh logSyslog logging: enabled (0 messages dropped, 32468 messages rate-limited, 0 fl...
The output is below. This is me dialing out from 6088777412 into our main line 8733379. At the greeting, I attempt the transfer to 18887450708.Thanks.----------------------------------------------------------Cisco2821#sh logSyslog logging: enabled ...
