Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2811 with CME 4.2 that is working fine for SCCP handsets, but I would like to use a couple of (non-Cisco) SIP devices. Is this possible? I can't find any good documentation on whether this is even possible, let alone how to do it!I am partwa...
Hi,I noticed in your config that you have two dn configured for pool 2, but they are both the same:voice register pool 2 number 1 dn 2 number 2 dn 2Should one of them been dn1 (both numbers ring on that phone)?Are the dial peers being created? show ...
PS, use the archive tar command to perform the upgrade (if you want to use the http interface to manage your switch and have downloaded the image with this included)
OK, that is a little closer, although I am not sure why the voice class doesn't work!I can now call from 7960 (SIP) to X-Pro and from 7960 to IP Communicator. I can also call from IP Communicator to both SIP clients.I cannot call from X-Pro to any SI...
When you upgrade the 3750 switch firmware, the master switch automatically copies the boot files to the flash of all member switches.The configuration file is shared by all members of the stack, so yes you only need to configure the boot statements o...
