Noticed  that a point to point OC3 circuit has a steady output drops without any other errors or  bandwidth issues. thoughts? POS1/0 is up, line protocol is up   Hardware is Packet over Sonet   Internet address is 10.20.54.1/29   MTU 4470 bytes, BW 155000 Kbit, DLY 100 usec,      reliability 255/255, txload 88/255, rxload 13/255   Encapsulation HDLC, crc 16, loopback not set   Keepalive set (10 sec)   Scramble disabled   Last input 00:00:00, output 00:00:00, output hang never   Last clearing of "show interface" counters 00:24:01   Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 3041   Queueing strategy: fifo   Output queue: 0/40 (size/max)   5 minute input rate 8149000 bits/sec, 5197 packets/sec   5 minute output rate 53735000 bits/sec, 6888 packets/sec      6656713 packets input, 1486058031 bytes, 0 no buffer      Received 145 broadcasts, 0 runts, 0 giants, 0 throttles               0 parity      0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort      8450106 packets output, 3048884844 bytes, 0 underruns      0 output errors, 0 applique, 0 interface resets      0 output buffer failures, 0 output buffers swapped out      0 carrier transitions POS1/0 is up, line protocol is up   Hardware is Packet over Sonet   Internet address is 10.20.54.1/29   MTU 4470 bytes, BW 155000 Kbit, DLY 100 usec,      reliability 255/255, txload 88/255, rxload 13/255   Encapsulation HDLC, crc 16, loopback not set   Keepalive set (10 sec)   Scramble disabled   Last input 00:00:00, output 00:00:00, output hang never   Last clearing of "show interface" counters 00:24:01   Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 3041   Queueing strategy: fifo   Output queue: 0/40 (size/max)   5 minute input rate 8149000 bits/sec, 5197 packets/sec   5 minute output rate 53735000 bits/sec, 6888 packets/sec      6656713 packets input, 1486058031 bytes, 0 no buffer      Received 145 broadcasts, 0 runts, 0 giants, 0 throttles               0 parity      0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort      8450106 packets output, 3048884844 bytes, 0 underruns      0 output errors, 0 applique, 0 interface resets      0 output buffer failures, 0 output buffers swapped out      0 carrier transitions ... View more

Is it possible to have or setup VPC on an ASA?   even if you are doing routing on the ASA? i was looking through: http://www.cisco.com/en/US/docs/switches/datacenter/sw/design/vpc_design/vpc_best_practices_design_guide.pdf anyone that has some experience with this i would appreciate it.            ... View more

Hi Everyone,        I wanted to ask if QoS is required on a PRI circuit?  the scenario is that SIP will be coming to the building but, it will be converted to PRI. therefore, it will not be on our MPLS cloud.   Therefore, i am trying to find a definitive answer if QoS is required still at this point. thank you in advance. ... View more

All,                  I wanted to verify that i could create a VACL to compensate for the session limitation of "2"  to create both an RSPAN and regular SPAN.  if someone could confirm that would be great. ... View more

All,    Trying to setup client VPN access on a 1841 router. essentially i would like to connect using  the cisco vpn application. any information would be appreciated. ... View more