Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here's my network setup:2x Nexus 7710 at the spine with HSRP (routing at the spine layer)2x Nexus 6001 running VPC+ (leaf layer 2 only)Fabricpath between the 6K and 7KTraffic to a vPC connected host on the N6K is load-balanced 50/50 between both Nexu...
Scenario:I have 2 PE routers connected to each other via 2960S and 3750 (non-metro) switches:[PE1] -- [2960S] -- [3750] -- [2960S] -- [PE2]I will be sending voice and data traffic between the two and my voice traffic will be marked DSCP EF & EXP 5.Si...
Hi,I have a route pattern 9.XXXXXXXXXX that points to a route-list.In the route-list, I have the following two route-groups pointing to the same CUBE: - RG #1 Predot - RG #2 Predot + Prefix 999 (used to do some OTG header manipulation in the CUBE)I d...
Hi,I'm running an ASA 5585 pair in transparent mode with two bridge-groups inside one context. The ASA is connected to a 6500 switch in VSS.In the logs, I'm seeing the MAC of the VSS cluster moving between between the two outside interfaces of my two...
Thanks, I'm having the same issue with a Nexus 6001 in my network causing packet loss after a switch reboot. FYI, the script works fine with NX-OS 6.0(2) but Python is broken in NX-OS version 7.0(x): there is no way to launch a script from the CLI, i...
