cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
662
Views
0
Helpful
1
Replies

Changing displayed dialed number on the phone

silemire
Level 1
Level 1

Hi,

I have a route pattern 9.XXXXXXXXXX that points to a route-list.

In the route-list, I have the following two route-groups pointing to the same CUBE:

- RG #1 Predot

- RG #2 Predot + Prefix 999 (used to do some OTG header manipulation in the CUBE)

I don't want users to see on their phones the 999 in front of their dialed number if the call gets routed to the 2nd route group.

I also don't want to set option "Always Display Original Dialed Number" to yes since it will break other things in our setup.

Is there a way to do this?

I'm using CUCM 8.5

-Simon

1 Reply 1

Karthik Sivaram
Level 4
Level 4

hi,

Use calling Party transformation for this at the

Route list or route pattern level.

Please find the details with the examples in the

doc below...

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080a87124.shtml#rlpage

Hope this helps!

Thanks,

Karthik