Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi There,I have Cisco 851 router and Cisco 100 series switch,The problem is here when i connect my router to network(Switch) .Ping goes to break .that why internet speed goes very down.Please suggest me what is exact problem going on.
HI all, I like to what is CEF and ASIC, and how is it work,please povide me any doc regarding this where i can get deep information about both.thankyou
i have two router both connect by serial link R1 and R2now what i want R2 recieve telnet on port 8000 not on port 23 from R1.Please tell me how can i do achive thiswhat i didi configure ip port mapconf tip port-map telnet port 8000 it is not working ...
ACC http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008009438e.shtml#diag this is lab i did, today,and offcouse i am able to understand this lab bus the confusion are 1 . why we use crypto map on both interface (p...
In my opinion there is some internal network problem,because there are five Ethernet wire go out from switch and that connect to netgear wifi router .so Is this possible that netgear wifi router giving me this problem.when i unplug the eternet wire...
there is command "IP ROUTING "this is global configuration command on switch L3,by this command you can communicate VLAN with each otherrouter(config-t)# ip routingthis is help ful for you.thankyou
Nat exempt is no longer support by now.,now youfirst you creat object group then you apply natTSee this is networkSent from Cisco Technical Support Android App
