Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I'm looking for some advice on router suitability for the following scenario:I require an inter vlan router to route approx 200 devices consisting of 150x PC's (Physical & Virtual) and 50x IP Phones. There will only be a maximum of 5x VLANs. ...
Hi All,I'm looking for some assistance on QoS policing configuration on an ASA 5505.The ASA is situated behind a cable modem which provides an SLA of 3.2Mbps out.I've configured a QOS policy to place VoIP and other essential traffic (RDP/Citrix/PCoIP...
Hi All,We have several Home Workers who establish a VPN tunnel to a PIX using a mixture of 871/877/851 routers.We've just replaced a single user's failed 877w with an 887w, who is now unable to establish end to end communication through the VPN tun...
Hi All,Can anybody recommend a Graphical Monitoring application to monitor Interface usage (Specifically Rx and Tx) with IOS based Routers/Switches.I am aware of obtaining current stats using sh int xx and monitoring the interface under SDM, but look...
Hi,I'm hoping for some assistance on Policing Voice RTP/Signalling traffic on an edge router connecting into an MPLS cloud.We are connecting VoIP (equipment does not support CAC) in addition to Data (Does not require prioritisation) and require the V...
Hi,I'm also in this same position with these errors and random disconnects for several seconds before reconnection is established. I have thus far spent 2 days looking at similar posts (Stops here) for likely settings and still no further forwards.S...
Hi,The other policy-map is left in there for historical reasons and I inherited that as is.The CPU runs between 18-23%, Memory at 200MB with no spikes or interface errors at the time the problem occurs., so very strange..Any further ideas would be ap...
Hi,Thanks for replying.Yes you are correct the service-policy QOS-TRAFFIC-OUT interface outside command was temporarily disabled from the sh run, to confirm the issue with rate drop is not due to the cable modem itself.I can confirm 100% this was in ...
Steven,Thanks for taking the time to reply.Interestingly the solution I got working was pretty much identical to yours, as I found exactly what you said in a lab environment (The priority queue completely starved the signalling).class-map match-any S...
