Hi,I have Catalyst 4507 R-E with one supersor engine n 3 other modules.My question is related to routing of different networks through this switch.I already have certain routes configured which are going to my ISP thru Juniper firewall.(192.168.0.9)I...
Hi,I have 2 cisco IP phones 7961g & 7945g.Both of these were used at different branch were the CUCM is placed.We have VPN connectivity to that branch,so we thought of placing these 2 phones at our branch.when i powered the IP phones( thru PoE switch)...
HiI'm unable to pass the required vlans networks to my firewall I have different vlans configured for each floor of the building,All these floors have Nortel switches which are connected to the core switch thru fibre link.I have a cisco 4507R-E core ...
Hi , I have some problem with the ASA 5510 ver 7.0(6). My manager wants to keep this as backup. tried lots of things but still users not able to access internet nor can i ping anywhere.For example when i ping 4.2.2.2 i dont get any reply.The runing ...
Hi Ajay ,As i mentioned earlier the phones are i blank /upgrade state .I' unable to check anything on the phone.But when i first got the phones the configuration was there according to that particular site.can u just tell me how to check whether the...
Hi Terry,Thanx for ur response. As i mentioned earlier the phones are connected to a 2960 PoE switch which is in turn connected to a 4507R-E core switch where the voice vlan n others are defined.The voice vlan is 22 n has all the info needed.The C...
Hi ,I was able to access the internet on 6th floor only.Other users on other floors still unable to access the internet .Kindly suggest me what else has to be one.
Hi Jouni,Thanx a lot for ur help.I disabled the older config by backing it up n tried a new config as u said n it worked.But the prob is i was able access on the 6th floor(on which my data room is located).when i tried accessing internet from other f...
Hi ,I'm really sorry for not mentioning this fact from the begining.Act all the users are accessing the internet thru Juniper i.e, 192.168.0.9 . Thats the reason u r seeing the default route in the config of switch.The requirement states that this...
