Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a problem. I have 2 4451's connected to a Layer 2 switch via BDI interfaces and running HSRP on the router. (see attached drawing). On the routers I also have 8 port NIM cards. I have a PC plugged into one of the NIM card ports and need to c...
I am trying to do a router on a stick configuration using BDI's and cant for the life of me figure it out. In the old IOS it was sub interface trunks etc this new one is excaping me... Attached is a drawing of a simple infrastructure I am trying to ...
I am new to this BDI thing on the new IOS... I am trying to setup a layer 2 SM switch module up on a 4451.I have a PC plugged into vlan666 and I can ping the router interface 10.16.202.1 but not the switch at 10.16.201.2.....I cant get it to work. he...
I have a 3825 with a etherswitch module in it.I can get to the etherswitch module virtlual console port by doing a session connection to the embeded router to switch conneciton.I have just found out that I can also get to the console port by doing a ...
I have a vlan trunked from a router to a layer 2 switch. What I would like to do is track the physical interface on the switch with the vlan interface on the router. For example when the vlan on the router is admin down I would like to have the inter...
it is a cisco 2811 with a 16 port switch module installed. The switch module is running 12. code and the router is running 15 dot code.... the diagram is pretty simple I have a device plugged into a port on the switch which has no ip address on it. i...
I know it is kinda weird. I have a script that runs on a computer that setups the PPOE dialer, turns on the vlan on the router and turns on the interface on the switch this is all done via calls to tcl. The PPOE address will vary via DHCP. After tha...
Bigger picture: I have a switch interface connected to a PPPOE dial up device. I control the PPPOE on the router Gig1/0/13... I can shut the vlan down and disable the PPPOE when necessary but the interface is still up and the device that is connected...
